Recent Articles
X-Series AVR and AV Processor Control System Drivers
For the XR-4, XR-6, XR-8, X7, and X9, and the XR-6S, XR-8S, X7S, and X9S, drivers for various control systems can be found here: https://avproglobal.egnyte.com/fl/U00ZckFzAH There are drivers and modules available for the following control systems: ...
Mixing AudioControl Dante amps and other Dante streams together.
An AudioControl Dante amplifier has 3 kinds of inputs: Local inputs Dante Inputs (streams) AudioControl Dante Streams Local Inputs Local Inputs are the RCAs and Digital inputs that are connected directly to the amplifier. In the Input Selection menu ...
Using the crossover on a Director Amplifier
The following information applies to the Director D2800, D4600, M4800, M4840, M6400, and M6800 amplifiers, and does not apply to the Dante CM amplifiers. Each zone on the Director amplifier has a crossover control with that can be used to create a ...
Using a Powered Subwoofer with a Director M-series amplifier
To add a powered subwoofer or a secondary subwoofer amp with your AudioControl Director amplifier, you can use the amp's Digital outputs to send signal to the subwoofer. Digital A & B outputs On an M4800, M4840, M6400, and M6800, the Digital A & B ...
How to use signal sense on a CM-series 70V amplifier
On the CM2-750, CM3-750, CM4-750, and their Dante-enabled counterparts, the zones can be turned on & off via IP command, 12V trigger, or Signal Sense. Check the following to make sure it works: Turn the zones ON. Turn global power ON, either via ...
Popular Articles
Firmware Update instructions for X7 and X9 processors and XR-4/6/8 receivers –using a USB drive.
Concert XR-4/6/8, XR-6S, and XR-8S receivers and Maestro X7/X9 and X7S/X9S processors: firmware update instructions Download Links: 4K XR-4, XR-6, XR-8 https://avproglobal.egnyte.com/fl/7bwxMJBPI3 4K X7, X9 ...
Firmware updates for Director/Director Matrix DSP amplifiers.
This article refers to firmware updates for the D4600, D2800, M6800, M6400, M4800, & M4840 DSP amplifiers. Download the firmware from the AudioControl website via the product page and log into the web interface by entering the IP address of the ...
Do you offer a replacement microphone for the Richter Scale Series III or the C-101 series III?
Unfortunately, we have sold out of the replacement microphone for the C-101 and Richter Scale products. We no longer have any in stock. We are very sorry for the inconvenience. If you are looking for the original manual for either of these products, ...
Control 4 SDDP settings: For X / XR series processors and receivers
The AudioControl X series processors and XR series receivers allow Control 4 programmers to enable SDDP (Simple Device Discovery Protocol) for automatic device recognition when setting up a Control 4 system. On the X series processors and XR series ...
Dirac Mic does not pick up Test Tones
During the volume calibration stage of Dirac, you may find that the microphone picks up voices just fine, but it doesn't seem to measure anything for test tones that Dirac plays through the speakers. This is typically caused by a setting on your ...
AudioControl Pro Knowledge Base