Can I turn on/off RS-232 control from the front panel of an AVR/M processor?
YES – By pressing and holding the DIRECT button for about 5 seconds. This will toggle RS-232 Control ON or OFF. If the Control setting is set to IP then pressing the DIRECT button for 5 seconds will set Control to OFF, pressing the Direct button again will turn RS232 Control ON.
Related Articles
Concert AVR-7 / AVR-9 and Maestro M5 / M9 Firmware, Manual, and Control System driver downloads
Here you will find all the important downloads for the AudioControl AVR-7 and AVR-9 receivers, and the M5 and M9 processors. In of the folders linked below, you'll find the latest firmware, user manuals, automation tables, and control system drivers ...
Triggering an RS 500 or RS 1000 amplifier on & off
There are a few ways to turn the RS amplifiers on and off, and depending on which one you wish to use, you might need to change. Trigger Methods Power Button The power button on the front panel of the unit will turn your RS amplifier on and put it ...
My Maestro processor or Concert receiver is on the network, but Dirac cannot find it!
First, make sure that the CONTROL setting in the setup menu is set to IP. Even if you will ultimately use RS-232 for control, the CONTROL setting needs to be set to IP in order for Dirac to see the processor or receiver on the network. For the ...
My Maestro processor or Concert receiver is on the network, but Dirac cannot find it!
First, make sure that the CONTROL setting in the setup menu is set to IP. Even if you will ultimately use RS-232 for control, the CONTROL setting needs to be set to IP in order for Dirac to see the processor or receiver on the network. For the ...
Dirac Live: Setup for Maestro M5/M9 processors and AVR 7/9 receivers.
Initial Setup Make sure the AVR 7/9 or M5/9 is connected to the same network as your computer. It doesn’t matter if the computer is connected via hardware or wifi, as long as it is on the same network. If your network is DHCP, the amplifier will ...