Does Signal Sense work with Dante Inputs?

Does Signal Sense work with Dante Inputs?

Yes!
If signal sense is On on your Dante amplifier and the zones are set to a Dante input, as soon as signal is sensed on that input the connected zones will turn on and output audio.

Signal sensing does not actively switch inputs, so if a zone is set to a local input and you start playing a Dante signal, that zone will not turn on. You will need to send IP commands via the web GUI or a control system to turn on a specific zone when an input is selected.

So, if you plan to use a Dante amp in a away where the zones will not change inputs, signal sense will always work. However, if you plan to switch inputs you will need to IP commands.
    • Related Articles

    • Using Dante with AudioControl

      An Introduction to Dante Dante is an exciting tool that allows AV installers to effortlessly transmit audio sources to multiple devices without any noticeable latency. In a typical matrix amp like our M6800, you have full 16x16 control, easily ...
    • Renaming Dante Inputs on your AudioControl Dante Amplifier

      Dante Input Names On AudioControl's Dante-enabled amplifiers, like the M4800D, M6800D, and the CM 70V Dante amps, the inputs shared between amplifiers will automatically display their chosen name when you click Look for Devices. For example, on your ...
    • How to use signal sense on a CM-series 70V amplifier

      On the CM2-750, CM3-750, CM4-750, and their Dante-enabled counterparts, the zones can be turned on & off via IP command, 12V trigger, or Signal Sense. Check the following to make sure it works: Turn the zones ON. Turn global power ON, either via ...
    • How to setup SDS – Signal Detection Switching – on Director and CM-70 volt matrix DSP amplifiers.

      The AudioControl Director Matrix series and CM 70 volt Matrix series amplifiers have a feature called SDS which stands for Signal Detection Switching. SDS allows you to connect the audio output of a doorbell system, home automation system, or a voice ...
    • Dante Best Practices Part 3: Using Dante Controller

      This is Part 3 in a series of articles about AudioControl Dante amps. If it's your first time setting up these amps, we highly recommend you read through Part 1: First Steps. To learn about connecting your AudioControl amps using Dante, check out ...