How do I control Zone 2 on my HTR-2 remote?

How do I control Zone 2 on my HTR-2 remote?

There is no dedicated “Zone 2” button on the HTR-2 remote.

So in order to put the AVR in Zone 2 mode, the user would press and hold the “amp” button and “OK” button on the remote.



The display would then change to show “Z2” and the volume and the input.  At this point you would be able to control that zone source or volume by using the HTR-2 remote.  You will also be able to turn the Zone on or put into standby using the power button on the HTR-2.

It’s also good to note that after  about 5 seconds or so, the amplifier will resort back to the Zone 1 control if it does not receive a signal from the HTR-2. At that point, you will have to press and hold the “amp” and “OK” button again on the remote, or push the Zone button on the amplifier again to put back into Zone 2 control.

For more information on our Concert AVR’s, click here.

For more info on our Maestro M9 see attached documents.

    • Related Articles

    • Controling Zone 2 on your X-series receiver/processor

      The remote that comes with our X-series receivers and processors does not have a dedicated Zone 2 button. In order to put the AVR in Zone 2 mode, press the “AMP” and “OK” buttons on the remote at the same time. The display will change to show Zone 2, ...

    • How do I program the HTR-3 & HTR-2 remotes.

      The HTR-3 and HTR-2 remotes have the ability to control multiple devices. It’s just a matter of programming the remote to take advantage of this feature. Find the appropriate code or codes for your device in the excel spreadsheet (see attached ...

    • How do I reset my HTR-2 remote to clear out all of the remote codes?

      Sometimes we make mistakes. Sometimes we put the wrong remote code into the remote and overwrite the correct code that does work. Have no fear! You can easily wipe the remote of any offending codes. All you have to do is press and hold both the ...

    • HT Remote app (Apple iOS only): X / XR series processors and receivers

      The AudioControl HT Remote app allows you to control your AudioControl X9 / X7 processor or XR8 / XR6 / XR4 receiver from your Apple iOS mobile device. Please refer to this Setup Menu article on how to access and navigate the setup menu options of ...

    • I have an old Maestro M1/2/3/4. But I don’t have a remote. Where can I get one?

      Up until the Maestro 6 we did not necessarily include remotes with the Maestro pre-processor. We supplied the IR codes with the manual so you can program a universal remote to control the Maestro. You can find the manuals for those older Maestros ...