I have an old Maestro M1/2/3/4. But I don’t have a remote. Where can I get one?
Up until the Maestro 6 we did not necessarily include remotes with the Maestro pre-processor.
We supplied the IR codes with the manual so you can program a universal remote to control the Maestro.
You can find the manuals for those older Maestros
here.
At the time, those Maestro’s were sometimes shipped with either a Universal Remote Control model MX-350, or a MX-500.
You can view our current version of the Maestro, the M9 attached to this article.
Related Articles
Dirac Live: Setup for Maestro M5/M9 processors and AVR 7/9 receivers.
Initial Setup Make sure the AVR 7/9 or M5/9 is connected to the same network as your computer. It doesn’t matter if the computer is connected via hardware or wifi, as long as it is on the same network. If your network is DHCP, the amplifier will ...
I get a blank picture when I connect my blu ray to my Convert AVR-7/9 or Maestro M9
All of the HDMI inputs on our Concert AVR-7/9 and Maestro M9 support HDMI 2.0 and HDCP 2.2 EXCEPT the STB/MHL input. That only supports up to HDMI 1.4. So, if you are using that input, first thing to do is try a different input. The Blu-ray might be ...
How do I control Zone 2 on my HTR-2 remote?
There is no dedicated “Zone 2” button on the HTR-2 remote. So in order to put the AVR in Zone 2 mode, the user would press and hold the “amp” button and “OK” button on the remote. The display would then change to show “Z2” and the volume and the ...
Concert AVR-7 / AVR-9 and Maestro M5 / M9 Firmware, Manual, and Control System driver downloads
Here you will find all the important downloads for the AudioControl AVR-7 and AVR-9 receivers, and the M5 and M9 processors. In of the folders linked below, you'll find the latest firmware, user manuals, automation tables, and control system drivers ...
My Maestro processor or Concert receiver is on the network, but Dirac cannot find it!
First, make sure that the CONTROL setting in the setup menu is set to IP. Even if you will ultimately use RS-232 for control, the CONTROL setting needs to be set to IP in order for Dirac to see the processor or receiver on the network. For the ...