What port do I use to connect to my Director amplifier for IP Control?
You can control our Director networked amplifiers via port 23 in either a telnet session or via your chosen automation system.
Related Articles
How to bridge amplifier channels on Director and Architect multi-zone home amps.
Introduction AudioControl Director and Architect series amplifiers have the capability to bridge amplifier channels together to deliver more power to your speakers. Bridging amplifier channels combines a stereo pair of channels into a single mono ...
How to setup SDS – Signal Detection Switching – on Director and CM-70 volt matrix DSP amplifiers.
The AudioControl Director Matrix series and CM 70 volt Matrix series amplifiers have a feature called SDS which stands for Signal Detection Switching. SDS allows you to connect the audio output of a doorbell system, home automation system, or a voice ...
What is the default IP address of my Director D/M, CM 70 volt, or RS series amplifier?
Default IP Address of AudioControl Amplifiers The default IP address for our Director/Director Matrix distribution amplifiers, CM 70 volt amplifiers, and RS 500/1000 subwoofer amplifiers is 192.168.0.249. If the amplifier does not receive an IP ...
Firmware updates for Director/Director Matrix DSP amplifiers.
This article refers to firmware updates for the D4600, D2800, M6800, M6400, M4800, & M4840 DSP amplifiers. Download the firmware from the AudioControl website via the product page and log into the web interface by entering the IP address of the ...
How to use Groups on the Director amplifiers
The AudioControl Director series amplifiers allow you to group 2 or more zones together so they act as one. This is useful if you have multiple sets of speakers for a single area, and you want them to all share the same input, volume level, and power ...