Is there Lip Sync (delay) on the Director amplifiers?
Yes! There is a Delay setting on The Director amplifiers. In our 16 channel amps, the setting is only present on Zones 5 – 8, and on our 8 channel amps it's available on all 4 zones. Control is from 0 – 19, in 5 ms increments for a total of 100 ms of delay.
The delay setting is found under the Global Settings under the Gear icon on the right side of the web interface.
Related Articles
Firmware updates for Director/Director Matrix DSP amplifiers.
This article refers to firmware updates for the D4600, D2800, M6800, M6400, M4800, & M4840 DSP amplifiers. Download the firmware from the AudioControl website via the product page and log into the web interface by entering the IP address of the ...How to bridge amplifier channels on Director and Architect multi-zone home amps.
Introduction AudioControl Director and Architect series amplifiers have the capability to bridge amplifier channels together to deliver more power to your speakers. Bridging amplifier channels combines a stereo pair of channels into a single mono ...How to setup SDS – Signal Detection Switching – on Director and CM-70 volt matrix DSP amplifiers.
The AudioControl Director Matrix series and CM 70 volt Matrix series amplifiers have a feature called SDS which stands for Signal Detection Switching. SDS allows you to connect the audio output of a doorbell system, home automation system, or a voice ...How to use Groups on the Director amplifiers
The AudioControl Director series amplifiers allow you to group 2 or more zones together so they act as one. This is useful if you have multiple sets of speakers for a single area, and you want them to all share the same input, volume level, and power ...How to assign a static IP address to my Director, CM, or RS series amplifiers?
This article refers to setting a static IP address on the Director and Director Matrix DSP amplifiers, CM series 70 volt amplifiers, and the RS500 or RS1000 subwoofer amplifiers. The example image below is for a Director amp running firmware 2.0.xx ...