What is the minimum voltage needed to trigger Signal Sense on my Architect multi-zone amplifier?

• Related Articles

• How to bridge amplifier channels on Director and Architect multi-zone home amps.

  Introduction AudioControl Director and Architect series amplifiers have the capability to bridge amplifier channels together to deliver more power to your speakers. Bridging amplifier channels combines a stereo pair of channels into a single mono ...

• How to use the 12 volt trigger options on an Architect amplifier.

  Architect amplifiers have both local zone 12 volt trigger connections and Master 12 volt trigger connections. The Local zone connection is a 3.5mm TS input connector. The Master trigger connection is either the 3-pin block connector or the two 3.5mm ...

• How to use signal sense on a CM-series 70V amplifier

  On the CM2-750, CM3-750, CM4-750, and their Dante-enabled counterparts, the zones can be turned on & off via IP command, 12V trigger, or Signal Sense. Check the following to make sure it works: Turn the zones ON. Turn global power ON, either via ...

• How to setup SDS – Signal Detection Switching – on Director and CM-70 volt matrix DSP amplifiers.

  The AudioControl Director Matrix series and CM 70 volt Matrix series amplifiers have a feature called SDS which stands for Signal Detection Switching. SDS allows you to connect the audio output of a doorbell system, home automation system, or a voice ...

• Does Signal Sense work with Dante Inputs?

  Yes! If signal sense is On on your Dante amplifier and the zones are set to a Dante input, as soon as signal is sensed on that input the connected zones will turn on and output audio. Signal sensing does not actively switch inputs, so if a zone is ...