X-Series AVR and AV Processor Control System Drivers
For the XR-4, XR-6, XR-8, X7, and X9, and the XR-6S, XR-8S, X7S, and X9S, drivers for various control systems can be found here:
There are drivers and modules available for the following control systems:
- Control4
- Crestron
- Crestron Home
- ELAN
- RTI
Related Articles
Web Interface not responding on X / XR-series processors and receivers
When you navigate to the IP address for your Maestro X series processor or Concert XR series receiver, you may find that changing the settings in the web interface does not affect any settings on the device. The web interface will not control the ...
Concert AVR-7 / AVR-9 and Maestro M5 / M9 Firmware, Manual, and Control System driver downloads
Here you will find all the important downloads for the AudioControl AVR-7 and AVR-9 receivers, and the M5 and M9 processors. In of the folders linked below, you'll find the latest firmware, user manuals, automation tables, and control system drivers ...
IP & RS232 Control Settings: X / XR series processors and receivers
Your AudioControl processor or receiver is able to be controlled with home automation systems such as Control4, Crestron, Savant, RTI, etc. Control can either be via IP, RS232, or IR. For control via IP or RS232 please adjust the following settings ...
Controling Zone 2 on your X-series receiver/processor
The remote that comes with our X-series receivers and processors does not have a dedicated Zone 2 button. In order to put the AVR in Zone 2 mode, press the “AMP” and “OK” buttons on the remote at the same time. The display will change to show Zone 2, ...
Dirac Live: Setup for X / XR series processors and receivers
This tutorial was written with Dirac version 3.4.4. Later versions of Dirac might have slight variations to the process. If you see something that doesn’t match with what you read in this guide, please call AudioControl tech support. The process for ...