Dante Best Practices Part 2: Setting up Dante
This is Part 2 in a series of articles about AudioControl Dante amps. If it's your first time setting up these amps, we highly recommend you read through Part 1: First Steps.
To learn more about using the Dante Controller with our amplifiers, check out Part 3: Using Dante Controller.
Setting up Dante
Step 1: Set IDs
You
can have up to 8 Dante-enabled AudioControl amplifiers connected
together, and each of them need to have their own ID number. In the
settings panel on the amp's web interface, open the Dante Configuration
tab, and select an ID between 1 and 8.
Go
through each amp in your system and give them their own ID. If you
named your amps Amp 1, Amp 2, Amp 3, etc, we recommend setting them with
ID 1, ID 2, and ID 3 respectively.
Step 2: Look for Devices
Once
all of the IDs are set, go through and click Look for Devices on each
amplifier. The amps' web pages will refresh, the available Dante amps in
the system will all appear under Remote Dante Devices, and all of their
inputs will be selectable in the input selection drop down menus.
And that's it! No step three, you are now able to switch audio between AudioControl amps with the press of a button.
Related Articles
Dante Best Practices Part 1: First Steps
This is Part 1 in a series of articles about AudioControl Dante amps. If it's your first time setting up these amps, we highly recommend you read through this first part! To learn about connecting your AudioControl amps using Dante, check out Part 2: ...Dante Best Practices Part 3: Using Dante Controller
This is Part 3 in a series of articles about AudioControl Dante amps. If it's your first time setting up these amps, we highly recommend you read through Part 1: First Steps. To learn about connecting your AudioControl amps using Dante, check out ...Using Dante with AudioControl
An Introduction to Dante Dante is an exciting tool that allows AV installers to effortlessly transmit audio sources to multiple devices without any noticeable latency. In a typical matrix amp like our M6800, you have full 16x16 control, easily ...Using the Control4 driver with your AudioControl Dante Amp
The Control4 driver for AudioControl’s Dante-enabled amplifiers makes setting up a large-scale Dante audio system easy in just a few steps. The process is the same whether you are using the M4800D, M6800D, or CM-70v Dante amplifiers. The Control4 ...Setting up Groups in a Director amplifier with Control4
You may have multiple sets of speakers you want to control in single area in your distributed audio system, the Grouping feature in the Director amps is here to help. Combine this with Control4 for a seamless user experience. Set up your groups in ...